Bring worn, peeling pavers back to life
Paver Restoration and Resealing in Greenland, FL
Call (904) 872-8339 for a free estimate on restoring and resealing tired Greenland pavers.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Can pavers in Greenland be restored instead of replaced?
Yes, a local contractor restores worn pavers at Greenland, FL homes, and a reply reaches you within 1 business day, usually much sooner. Looking at the surface and writing the price cost nothing. To get a time, call (904) 872-8339.
Restoration is for pavers that look old, not broken: color gone flat, sealer peeling in patches, joints open and stains set in. Replacing them is a big job that tears up the yard and the budget, and most of these surfaces clean up well with the right steps in the right order. Say what bothers you most, and how long it has looked that way, when you ask for a free estimate.
What is the difference between paver restoration and resealing?
Resealing puts a coat on pavers that are clean and in good shape. Restoration is the longer route for surfaces where the old coat has failed. A Duval County washing company says empty joints or failed sealer mean a two day restoration, not a same day spray. Compare the two when you call (904) 872-8339.
The order of work is the heart of it: wash, strip failed coating, re-sand, let the surface dry, then seal. Skip a step and the new coat carries the old problems with it. Ask a contractor to walk you through the sequence at the visit, and ask for a free estimate.
How do I know my pavers need restoring and not just a rinse?
Look for sealer that flakes or peels, a milky film that will not wash off, joints sunk below the edges and color that stays flat even when wet. Stallone's Pro Wash says that when water stops beading and soaks in fast, it is time for a fresh coat. Peeling or cloudy coating usually means a strip first. To have it judged, call (904) 872-8339.
Why must failed sealer be stripped and not sealed over?
A new coat only holds as well as what is under it. A Duval County washing company says failed sealer gets stripped, not coated over, and Stallone's Pro Wash says it strips first, then reseals. Unilock adds that sealer can accentuate stains, so cleaning comes before any coat. Ask what stripper is used and whether a small test patch comes first. To raise it, ask for a free estimate.
Western Interlock, a paver maker, suggests trying a stripper on a small area first. A careful contractor does the same, because pavers vary in color and age. Stripping is also the reason a restoration quote sits higher than a plain reseal. Confirm the plan at (904) 872-8339.
How do joints get refilled during a restoration?
Summer storms wash sand out of joints, and low joints let pavers shift and weeds root. Stallone's Pro Wash sweeps kiln dried Trident sand graded to ASTM C144 into the joints and compacts it. It avoids polymeric sand because that product needs dry days to cure and can leave a haze. Ask which sand your contractor uses when you call (904) 872-8339.
Does the weather change how a restoration is scheduled?
Yes, it can move both days. Unilock asks for clear skies for 24 to 48 hours before sealing, temperatures from 50 to 90 degrees with 75 ideal, and dry weather for up to 48 hours after. A Duval County washing company names fall as the right season to seal. Summer thunderstorms in Greenland mean flexible dates help. To pick a window, ask for a free estimate.
One more check: Western Interlock suggests taping plastic sheeting over a patch and looking for condensation. None means dry enough. Turning sprinklers off while the coat cures matters too, as Unilock notes. Tell the contractor your sprinkler schedule when you call (904) 872-8339.
What does restoration mean for pavers near Greenland creeks and pines?
Pavers shaded by pines or sitting near damp ground take on green film and needle stains, and they dry slowly. Big Davis Creek and Julington Creek keep the ground damp across this part of Duval County. Slow drying stretches the schedule, so a rushed job on shaded pavers is the one to question. To plan around your yard, call (904) 872-8339.
Shaded driveways
Pine shade keeps film on the surface and slows the drying that a sealer needs.
Entry courts
Weathered coating shows first where feet and tires pass, so these peel first.
Pool decks
Chlorine and sun wear the coat faster; a Duval County washing company says it can pull a reseal toward two years.
Back patios
Joints that storms emptied show up here as weeds and sunk pavers.
What does the paver restoration process include, step by step?
Five steps cover most jobs, and the days are split by drying time. A contractor measures and notes loose pavers, then washes and strips, treats stains, refills the joints and seals on a dry surface. For a schedule that fits your week, ask for a free estimate.
1. Inspect and measure
Rocking pavers, low spots and standing water are marked before any price is set.
2. Wash and strip
Organic growth, stains and failed coating come off, with a test patch on the stripper first.
3. Re-sand the joints
Kiln dried sand is swept in and compacted; damp sand is fine, puddles are not.
4. Let it dry
A day of dry surface, checked for moisture, before any coat goes on.
5. Seal and cure
The sealer is applied evenly, then foot and car traffic stay off for the stated time.
What does paver restoration cost in Greenland?
Published local figures run $1.75 to $3.25 per square foot to clean, sand and seal. Stallone's Pro Wash lists washing from $0.22 and sealing from $1.90. A strip and reseal sits higher, according to a Duval County washing company, and no page gives a number for it, so this site does not either. For a written price, ask for a free estimate.
The price moves with how much old coating is left, how many joints are empty and how much staining there is. Ask which of those three drove each line. Have a bid already? Call (904) 872-8339 and set the two side by side.
| Paved area | Example | Wash only, from $0.22 | Clean, re-sand and seal range |
|---|---|---|---|
| 400 sq ft | Patio and front walk | $88 | $700 to $1,300 |
| 800 sq ft | Two car driveway | $176 | $1,400 to $2,600 |
| 1,200 sq ft | Driveway and entry apron | $264 | $2,100 to $3,900 |
| 1,600 sq ft | Driveway plus pool deck | $352 | $2,800 to $5,200 |
Stripping failed sealer sits above this range, according to a Duval County washing company, and no page read for this site gives a figure for it. Rates are the $0.22 washing starting rate from Stallone's Pro Wash and the $1.75 to $3.25 clean, sand and seal range from the washing company. A strip and reseal quote is set after someone sees how much old coating is left.
Which pavers around Greenland can be restored?
Driveways, pool decks, patios, entry courts and walkways can all be restored. Two limits apply. Pavers that sank or rock underfoot need their base fixed first, and sealing is not a cure for poor drainage, as Unilock says. For a look at your surface, call (904) 872-8339.
Which Greenland neighborhoods can get paver restoration?
A local contractor covers Greenland and nearby places, and every town below has its own page. Areas across Duval and Clay counties and the counties next door are covered. If your street is missing, ask for a free estimate.
- Durbin
- Beauclerc
- Saint Johns
- Fruit Cove
- Baymeadows
- Mandarin
- San Jose
- Nocatee
- Southside
- Fleming Island
- San Pablo
- Palm Valley
- Sandalwood
- Ponte Vedra Beach
- Bellair-Meadowbrook Terrace
- San Marco
- World Golf Village
- Lakeside
- Argyle Forest
- Arlington
- Jacksonville Beach
- Cedar Hills
- Riverside
- Fort Caroline
- Atlantic Beach
- Oakleaf Plantation
What do restored pavers look like around Greenland?
Frequently Asked Questions About Paver Restoration
Is sealing pavers worth it in Florida?
Yes, on pavers that have faded, lost sand or started to grow film. Unilock says sealer deepens color and helps guard against water, dirt and oil. A restoration goes further, because it also resets the joints, and the order of the work counts.
Can I use Dawn dish soap to clean my pavers?
That is a home trick, and a restoration contractor works differently. Stallone's Pro Wash says cleaning has to remove organic growth, staining and debris that plain washing misses. Ask what cleaner and tool the contractor plans to use.
Why is paver sealing so expensive?
Most of a restoration price is prep. A Duval County washing company calls it a two day job, not a same day spray, and says failed sealer is stripped before anything new goes on. The sealer itself is the smaller piece.
How much should I pay for paver sealing?
Published local figures run $1.75 to $3.25 per square foot to clean, sand and seal. Stripping failed sealer sits above that. An 800 square foot driveway comes to about $1,400 to $2,600 on the range, before repairs.
What is the average cost to seal pavers in Florida?
Around the First Coast, companies publish about $1.75 to $3.25 per square foot for the whole clean, sand and seal job. Stallone's Pro Wash lists sealing alone from $1.90. Restoration with stripping runs higher.
Can old sealer be sealed over instead of stripped?
Failed sealer should come off first. Stallone's Pro Wash says it strips before resealing, and a Duval County washing company says failed sealer gets stripped, not coated over. A new coat over a peeling one fails with it.
What is the difference between resealing and restoration?
Resealing adds a coat to pavers that are clean and sound. Restoration cleans, strips any failed coating, refills empty joints and then seals. Pavers with worn coating, low sand or stains usually need the second one.
How long does a paver restoration take?
Plan on two days. A Duval County washing company says empty joints or failed sealer call for a two day restoration. The pavers have to dry between washing and sealing, and weather can move the second day.
Why does sand wash out of my driveway joints in summer?
Heavy summer rain moves loose sand. A Duval County washing company says storms wash sand out of driveways and pool decks. Kiln dried sand is swept in after washing, and the surface dries before any coat.
How long should I wait before sealing new pavers in Greenland?
Unilock says to wait 60 to 90 days for new pavers, so a white haze called efflorescence can clear. It typically fades in 2 to 3 months and can take up to a year. Sealing too soon traps it.
Want your old pavers looking new again?
Dial the number or fill in the form, and someone local who restores pavers answers within 1 business day, usually much sooner.
Free, no obligation